This is a working overview of thymosin alpha-1, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2025-09-20. Anything still debated is marked as such rather than presented as settled.
Identity and purity are normally confirmed by reversed-phase high-performance liquid chromatography and mass spectrometry. The expected mass for the acetylated 28-residue peptide is close to 3108 daltons, and a mass shift indicates a modification or truncation. Peptide mapping after enzymatic digestion can resolve sequence-level questions. Counter-ion content, water content, and residual solvents are separate quality attributes that a certificate of analysis may or may not report. Aggregation is monitored by size-exclusion chromatography when relevant.
Thymosin alpha-1 is supplied as a lyophilized powder in most research settings. The solid dissolves readily in water and in common aqueous buffers, and it is typically reconstituted shortly before use. Solutions are clear and colourless at ordinary working concentrations. Because the peptide is hygroscopic, weighing and reconstitution are usually performed with minimal exposure to ambient air. Aliquots are prepared to avoid repeated freeze-thaw cycles, and working solutions are kept cold.
Long-term storage is generally at minus twenty degrees Celsius or colder, preferably desiccated and protected from light. Lyophilized material is more stable than reconstituted solution, which degrades faster at room temperature. Stability depends on pH, ionic strength, and the presence of oxidising agents. Published stability data for the peptide are limited, so storage claims in catalogues should be treated as general guidance rather than measured guarantees. Freeze-thaw cycles are kept to a minimum.
Early work on thymic extracts in the 1960s described a heat-stable acidic fraction containing many polypeptides. Separation of that mixture yielded individual components, and thymosin alpha-1 was named as one of them on the basis of assays for T-cell activity. The first preparations came from calf thymus, while subsequent research and clinical material has been chemically synthesized. Nomenclature in older papers is inconsistent, and the same peptide sometimes appears under different designations, which complicates literature searches.
Most published studies on thymosin alpha-1 report changes in immune measurements rather than clinical outcomes, and findings differ across designs and populations. Whether the peptide signals through one defined receptor or through several less specific interactions remains an open question. Its reported circulation half-life of a few hours complicates comparison of dosing schedules across trials. Mechanistic claims are frequently drawn from isolated cell cultures, and how far those results extend to whole organisms is unresolved.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilized form |
| Solubility | Soluble in water | Also soluble in aqueous buffers |
| Storage temperature | -20 °C or below | Desiccated, protected from light |
| Typical analytical method | RP-HPLC with mass spectrometry | Purity and identity |
| Common synonyms | Thymalfasin, T alpha 1 | Sequence identical to natural fragment |
protein with a deep cleft for binding the RNA substrate. The first layer is composed of three alpha helices (residues 3–13, 24-34 and 50–60) from the N-terminal half of the protein. The second layer consist of three β-hairpins (residues 61–74, 79-104 and 105-124 from the C-terminal half) arranged in two β-sheets. The hairpins 61-74 and 105-124 form a four-stranded, antiparallel β-sheet that lies on helix 3 (residues 50–60). The longest β-hairpin 79-104 mates with a short β-strand (residues 42–45) to form a three-stranded, antiparallel β-sheet that lies on helix 2 (residues 24–34). RNase A has four disulfide bonds in its native state: Cys26-Cys84, Cys58-110, Cys40-95 and Cys65-72. The first two (26-84 and 58–110) are essential for conformational folding; each joins an alpha helix of the first layer to a beta sheet of the second layer, forming a small hydrophobic core in its vicinity. The latter two disulfide bonds (40-95 and 65–72) are less essential for folding; either one can be reduced (but not both) without affecting the native structure under physiological conditions. These disulfide bonds connect loop segments and are relatively exposed to solvent. The 65-72 disulfide bond has an extraordinarily high propensity to form, significantly more than would be expected from its loop entropy, both as a peptide and in the full-length protein. This suggests that the 61-74 β-hairpin has a high propensity to fold conformationally. RNase A is a basic protein (pI = 9.63); its many positive charges are consistent with its binding to RNA (a poly-anion).
== Correlation == It has been found that the F number linearly correlates with the log k' value (logarithm of the retention factor) in aqueous reversed-phase liquid chromatography. This relationship can be used to understand the significance of different aspects of molecular architecture on their separation using different stationary phases. This size analysis is complementary to the length-to-breadth (L/B) ratio, which classifies molecules according to their "rodlike" or "squarelike" shape.
Notes: % monoesters and HLB reported in this table are the approximative values indicated by the suppliers for each blend. B= Behenate (22 carbon chain) - S = stearate (18 carbon chain) - O = Oleate (18 carbon chain, 1 unsaturation) - P = Palmitate (16 carbon chain) - M = myristate (14 carbon chain) - L = Laurate (12 carbon chain) It means that a transposition of the HLB scale of the PEO surfactants has been made for defining the HLB of sucrose esters, because both families of surfactants are non-ionic surfactants. There are two issues with this transposition. The first one is that in this numerical transposition of the Griffin's scale to sucrose esters, the monoesters content is supposed to correspond the hydrophilic part of the surfactant what is a strong approximation because the monoesters fraction is not purely hydrophilic, since it also contains a high proportion of hydrophobic fatty chains in mass percent. It means also that, for example, a sucrose laurate blend (a sucrose grafted with a 12 carbon fatty acid) and a sucrose stearate blend (a sucrose grafted with a 18 carbon fatty acid) have the same HLB (see Table), despite the fact that sucrose laurates are really more hydrophilic and water-soluble than sucrose stearates. The second issue is that this HLB scale, established for non-ionic PEO surfactants on the basis of experimental data, is valid only for the latter. This scale has a genuine predictive value for choosing the right PEO surfactant for a given application, typically oil-in-water or water-in-oil emulsification.
MHC Class II molecules are a class of major histocompatibility complex (MHC) molecules normally found only on professional antigen-presenting cells such as dendritic cells, macrophages, some endothelial cells, thymic epithelial cells, and B cells. These cells are important in initiating immune responses. Antigens presented by MHC class II molecules are exogenous, originating from extracellular proteins rather than cytosolic and endogenous sources like those presented by MHC class I. The loading of a MHC class II molecule occurs by phagocytosis. Extracellular proteins are endocytosed into a phagosome, which subsequently fuses with a lysosome to create a phagolysosome. Within the phagolysosome, lysosomal enzymes degrade the proteins into peptide fragments. These fragments are then loaded into the peptide-binding groove of the MHC class II molecule. Once loaded, the MHC class II-peptide complexes are transported to the plasma membrane via vesicular transport, where they present the antigens to the extracellular environment. In humans, the MHC class II protein complex is encoded by the human leukocyte antigen gene complex (HLA). Class II HLAs are composed of the classical HLA-DP, HLA-DQ, and HLA-DR and non-classical HLA-DM and HLA-DO MHC molecules.
Sources: en.wikipedia.org
==== Out of favour ==== On 4 November 2015, having not started a league match of the 2015–16 season, Townsend was dropped from the squad following a touchline argument with the club's fitness coach. He apologised, and Pochettino allowed him to return to the squad by 17 November, stating that the matter was over and he was available for selection again. He was an unused substitute three times following the incident, the last of which was on 10 December, but made no more first-team appearances for Tottenham.
Although very small amounts of berkelium were possibly produced in previous nuclear experiments, it was first intentionally synthesized, isolated and identified in December 1949 by Glenn T. Seaborg, Albert Ghiorso, Stanley Gerald Thompson, and Kenneth Street Jr. They used the 60-inch cyclotron at the University of California, Berkeley. Similar to the nearly simultaneous discovery of americium (element 95) and curium (element 96) in 1944, the new elements berkelium and californium (element 98) were both produced in 1949–1950. The name choice for element 97 followed the previous tradition of the Californian group to draw an analogy between the newly discovered actinide and the lanthanide element positioned above it in the periodic table. Previously, americium was named after a continent as its analogue europium, and curium honored scientists Marie and Pierre Curie as the lanthanide above it, gadolinium, was named after the explorer of the rare-earth elements Johan Gadolin. Thus, the discovery report by the Berkeley group reads: "It is suggested that element 97 be given the name berkelium (symbol Bk) after the city of Berkeley in a manner similar to that used in naming its chemical homologue terbium (atomic number 65) whose name was derived from the town of Ytterby, Sweden, where the rare earth minerals were first found." This tradition ended with berkelium, though, as the naming of the next discovered actinide, californium, was not related to its lanthanide analogue dysprosium, but after the discovery place.
Interferon beta-1a is available only in injectable forms, and can cause skin reactions at the injection site that may include cutaneous necrosis. Skin reactions with interferon beta are more common with subcutaneous administration and vary greatly in their clinical presentation. They usually appear within the first month of treatment albeit their frequence and importance diminish after six months of treatment. Skin reactions are more prevalent in women. Mild skin reactions usually do not impede treatment whereas necroses appear in around 5% of patients and lead to the discontinuation of the therapy. Also over time, a visible dent at the injection site due to the local destruction of fat tissue, known as lipoatrophy, may develop, however, this rarely occurs with interferon treatment. Interferons, a subclass of cytokines, are produced in the body during illnesses such as influenza in order to help fight the infection. They are responsible for many of the symptoms of influenza infections, including fever, muscle aches, fatigue, and headaches. Many patients report influenza-like symptoms hours after taking interferon beta that usually improve within 24 hours, being such symptoms related to the temporary increase of cytokines. This reaction tends to disappear after 3 months of treatment and its symptoms can be treated with over-the-counter nonsteroidal anti-inflammatory drugs, such as ibuprofen, that reduce fever and pain. Another common transient secondary effect with interferon-beta is a functional deterioration of already existing symptoms of the disease.
Sources: en.wikipedia.org
The least expensive diffusion pump oils are based on hydrocarbons which have been purified by double-distillation. Compared with the other fluids, they have higher vapor pressure, so are usually limited to a pressure of 1×10−6 Torr (1.3×10−4 Pa). They are also the most likely to burn or explode if exposed to oxidizers. For pumping reactive species, usually a polyphenyl ether based oil is used. These oils are the most chemical and heat resistant type of diffusion pump oil.
13 December Mark Drakeford resigns as First minister of Wales after five years in incumbent. Bernard Looney, the former chief executive of BP, is to forfeit up to £32.4m in salary and benefits after an investigation found he committed "serious misconduct" in failing to disclose relationships with colleagues. 14 December The Bank of England keeps interest rates on hold for a third consecutive time at 5.25%. 17-year-old Alex Batty, a boy from Oldham who went missing in 2017 while on holiday in Spain, is reported by French Police to have been found at Revel, a town east of Toulouse in France. Three men are convicted of attempted murder after two children (including an 11-year-old girl) were shot while playing on a climbing frame, in Wolverhampton. Panini Group launches the first sticker album for the Women's Super League. 15 December The High Court rules that Prince Harry was the victim of phone hacking by Mirror Group Newspapers and awards him £140,600 in damages. Separately, the judge rules that Piers Morgan knew about phone hacking – and was involved – while editor of the Daily Mirror. Muslim convert Edward Little, who planned to kill a Christian preacher at Speaker's Corner in London's Hyde Park, is sentenced to life imprisonment with a minimum term of 16 years following a trial at the Old Bailey. Network Rail regional manager Michelle Handforth resigns from her post following a power outage at Ladbroke Grove earlier in the month which left hundreds of train passengers stranded for several hours.
The most common ionization method coupled to LC is some form of spray ionization, which includes thermospray ionization and more commonly, electrospray (ESI) ionization. Thermospray was first developed as a way to effectively remove solvent and vaporize samples more easily. This method involves the liquid sample from the LC flowing through an electrically heated vaporizer that simply heats the sample, removing any solvent and therefore putting the sample in the gas phase. Electrospray ionization (ESI) is similar to thermospray in the principle of removing the liquid solvent from the sample as much as possible, creating charged sample molecules either in small droplets or in gas form. Studies have shown that ESI can be as much as ten times more sensitive than other ionization methods coupled to LC. The spray methods are particularly useful considering that non-volatile samples can be analyzed easily through this method since the sample is not itself turned into a gas, the liquid is simply removed, pushing the sample into a gaseous or mist phase. One sample preparation issue with liquid chromatography-mass spectrometry is possible matrix effects due to the presence of background molecules. These matrix effects have been shown to decrease the signal in methods such as PI and ESI by amounts as much as 60% depending on the sample being analyzed. The matrix effect can also cause an increase in signal, producing false positive results.
Sources: en.wikipedia.org
Lyophilized powder is normally kept at minus twenty degrees Celsius or below, in a sealed container, desiccated and away from light. Reconstituted solutions are less stable and are usually refrigerated and used quickly. Repeated temperature cycling should be avoided.
Mass spectrometry gives the molecular mass, which is compared with the calculated value. Reversed-phase liquid chromatography shows purity and the presence of related impurities. Peptide mapping can verify the amino acid sequence when a higher level of detail is needed.
It reports the tests the supplier performed, which may vary between laboratories and lots. Methods and acceptance criteria are not standardised across suppliers. Buyers often request the actual chromatograms and spectra rather than a summary statement.
Its sequence corresponds to the amino-terminal portion of prothymosin alpha, a larger protein present in many cell types. The isolated 28-residue peptide is a fragment of that protein rather than a separately encoded molecule, and laboratory material is produced by synthesis.